Front tandwiel
Geplaatst: zo 09 jan 2005, 23:31
Hi forum.
I think I may have a problem
The horisontal tube, just after the rear wheel, is welded alittle close to the wheel, and I have mounted the engine onto the frame, so the chain will run right underneath it! There's not much space between the tube and the chain, but the tandwiel that is on the engine, is a 10 tands! And the rear tandwiel is a 22 tands, so I'll probably have to put on a bigger tandwiel on the engine, and then it will hit the horisontal tube But I can grind off some metal on the tube, but I think I would have to grind too much off, before It won't hit ? Will a 10 tands tandwiel be too little? And do I then have to put on a bigger tandwiel? Any sugestions? Im just afraid that 10 tands is too little, and it will go with too much rpm.
I think I may have a problem
The horisontal tube, just after the rear wheel, is welded alittle close to the wheel, and I have mounted the engine onto the frame, so the chain will run right underneath it! There's not much space between the tube and the chain, but the tandwiel that is on the engine, is a 10 tands! And the rear tandwiel is a 22 tands, so I'll probably have to put on a bigger tandwiel on the engine, and then it will hit the horisontal tube But I can grind off some metal on the tube, but I think I would have to grind too much off, before It won't hit ? Will a 10 tands tandwiel be too little? And do I then have to put on a bigger tandwiel? Any sugestions? Im just afraid that 10 tands is too little, and it will go with too much rpm.