minibike-forum.nl

The averages that but need to me are the one of the wheelbase and the degrees of the direction. as I can put photos?

Degrees of the front-fork:

When putting a straight line up, from the ground, the front-fork must have an angle of 24 degrees at the vertical line.

The distance between the wheels.
From centre to centre: about 730mm.

Front-fork is most of the time between 390 and 420 mm
This is measured from wheelcentre to the above of the fork.

The height from the ground to the backside of the seat is about 600mm

It can be lower, you can take the 600mm as a maximum size.

A little drawing... it sucks... i hope you get it:

Afbeelding

ok, thank you very much. The tubes, of which measured they go well? I can use tube of 16 milimetros?

doraimontv schreef:ok, thank you very much. The tubes, of which measured they go well? I can use tube of 16 milimetros?

I use 15mm, and 1.5mm thick.

ok
Thank you very much by everything. I must myself lay down, is late. Tomorrow I follow with the questions and I put photos of my block. thanks for everything.

No thanx

We`ll be waiting for your pictures !

Untiej Mini Racing

I cannot translate this well:

Front-fork is most of the time between 390 and 420 mm
This is measured from wheelcentre to the above of the fork.

doraimontv schreef:Untiej Mini Racing

I cannot translate this well:

Front-fork is most of the time between 390 and 420 mm
This is measured from wheelcentre to the above of the fork.

Front fork is "frunza el tenedor"

390mm to 420mm you do understand I think.

This is measured from wheelcentre to the above of the fork.
- I want to draw this for you. Give me a moment.

I'm done.
http://img98.imageshack.us/my.php?image=naamloos4by.jpg

If, already it and understood.

But this measure gives the tenedor, not?

My holder is a copy of a blata.

In 10 hours or this way I put photos of what I have.

Thank you very much.