Suspect's minibike project *ALLMOST DONE*

[Markie]

hehe,
I can see a minibike in it, so I'm for sure it's going to be a very well bike!

Ow, nice buy Co2 welder hehe

[Gast]

I allready knew that, it had to be under 90 degrees, so I took the dirty job, and cutted it..

Here is a picture of the bike, as how I allmost wan't it to look, the frame has to be higher though..


I forgot to post a picture of the tandwiel, with my homemade adaptor. I think the adaptor went out to be quite nice!? Do you think it will last? Or is there too much pressure from the chain, so it will get broke? The bolts, inside the naaf, is just pressing up against the "wall"..


More pictures will come.

[John_W]

No comments regarding the frontfork anymore. You did a good job .

But... a new suggestion for the rearsprocket. Please invert the position of the bolts and the nuts (I mean the nyloc nut inside the breakdrum). When fore some reason the chain wil come off the sprocket, there is more space available and the damage to the frame will be less

[Gast]

heey mensen !

ff comentaar in het nederlands !
kan hij straks als hij een polinni 911 tankje erop wil zetten deze er wel op maken ? omdat hij nog een extra strip als het ware heeft tussen zijn linker en rechter deel van zijn frame ! die aan de bovenkant bedoel ik dan bij zijn balhoofd ! of heb ik dat mis ??

[Jeroen]

volgens mij komt het tankje bovenop het frame niet ertussen...

[Gast]

John_W I don't understand..? You mean, the chain will fall of if I don't turn the bolts?

[Gast]

can someone translate aj ?

[Jeroen]

AJ asked if it is possible to fit a Polini 911 tank on your frame.

and i replied that i think it won't be a problem.

[John_W]

Why comments in Dutch AJ ? Good opportunity to practice our English language. Michael, I sended you a PB to explain more about your question.

[Gast]

Ok thanks John!

Hehe, free english lessons I just really can't speak german or dutch Btw. I got new pictures! I went over to my uncle, so he could weld the last bit of the frame, with his ESAB welder, so I would be sure that the frame would hold.. It went out very nice in my oppinion



While I was outside, I found this on my trailer!?


More and more pictures will come!

[Markie]

hehe, I'm happy i live in the Netherlands!!!
BRRRR snow.... I dont like cold weater brrr

[Gast]

hehe, I don't think it's that bad

Today I ordered Polini parts. The 911 tank and seat, in black

And Polini said that the parts would probably come tomorrow, if not, they will come right after christmas, but im hopping that they will come tomorrow

I will update with pictures, when I get the parts

[Gast]

Yes!

Just as I hoped, the shields arrived today

They are so nice

[Gast]

hallooo

I mounted my shields with tape, so I could see if the length of the fork was right. I think it looks really good




Here's some stickers, and the grips for the bike.

[üntiej#21]

Looking good !

Wich collors do you think it wil be ?

And what are you gonna do @ you engine.. to make it fast

Greetz